Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to specify inlet, outlet and wall for this geometry?

Please login with a confirmed email address before reporting spam

Hii

The 3D geometry contains a catalyst bed of 5 layers as shown in the attached file. How to specify inlet, outlet and wall for this geometry? Water and Nitrogen will be flowing form the top of the bed to the bottom. Do I have to select each spherical particle form the top layer as a part of manual selection for the inlet and similarly for the outlet. But this is not working out. Please help me.

Thanks

0 Replies Last Post 23 févr. 2011, 08:26 UTC−5
COMSOL Moderator

Hello Pardha Saradhi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.