Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Reaction stoichiometry calculation issue

Please login with a confirmed email address before reporting spam

I'm trying to model an ammonia decomposition reactor, in which my overall reaction is

NH3 <-> (3/2)H2 + (1/2)N2

Yet, my model seems to have two issues at the moment:

1) The number of moles in my output upon nearly complete conversion is not twice my input (as dictated by the stoichiometry - see Derived Values: line integrals in solution)

2) The ratio of H2/N2 in the output is not 3/1 (again, as stoichiometry suggests - see Mole Fraction plots in solution)

I assume it is some peculiar input method I have done incorrectly, so I was hoping someone with experience might be able to tell me what's gone wrong.

This model uses v5.3 and has the Chemical Engineering Module. I am specifically using the Free and Porous Media Flow + Heat Transfer in Porous Media + Transport of Concentrated Species.

Also, I tried using two types of reaction terms in the Transport of Concentrated Species (Reaction and Reaction Source) but both give similar results.

Can anyone provide feedback on possible causes for these discrepancies? I appreciate any time and effort you may provide. Thanks.


0 Replies Last Post 16 juin 2017, 14:56 UTC−4
COMSOL Moderator

Hello Sean Lundin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.