Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

connecting imported stl mesh with comsol geometry for simulation

Please login with a confirmed email address before reporting spam

HI,
I have imported a mesh in stl. format to comsol and have a 3d gemetry buit in comsol. I am unable to connect both the assemblies to run heat simulation in comsol and thus to see the effect of heating by the geometry on the mesh.
Can anyone please guide as to how do i bring the two assemblies together and can then rum simulation on it.
Your Help is urgently required and i will be very grateful.
Thanking You.
I.A

0 Replies Last Post 12 avr. 2011, 13:17 UTC−4
COMSOL Moderator

Hello isshaa aarya

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.