Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

A problem about the well boundary condition in the Darcy's law module

Please login with a confirmed email address before reporting spam

There seems to be a problem with well boundary conditions when simulating reservoir production processes by the Darcy’s law module. I assigned Neumanna boundary conditions (constant mass flow) to the injection and production wells, and then the calculation was perfomed smoothly. In post-processing, I used the Darcy’s velocity to solve the mass flux of the production well, but I found that the mass flux calculated by the integral was inconsistent with the pre-prescribed mass flux. So, when I simulate the production process using the well boundary conditions with the specified production pressure, is it suitble to calculate the productivity by the the Darcy's velocity? Can someone give me some advice?

Thanks!


0 Replies Last Post 15 janv. 2019, 02:35 UTC−5
COMSOL Moderator

Hello Songcai Han

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.