Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

modelling and simulation of SAW device using reflectors

Please login with a confirmed email address before reporting spam

hi, I need to model a SAW device and then simulate it using comsol multiphysics. The device I need to fabricate must be simulated first so as to reach the optimality. I need to do this using coupling of modes model. Your help in modelling the device will be highly valuable for me and my department.


0 Replies Last Post 7 août 2019, 06:39 UTC−4
COMSOL Moderator

Hello RAJAT SRIVASTAVA

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.