Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how can see the total heat source at boundaries???

Please login with a confirmed email address before reporting spam

Hi everyone,

currently, i am using comsol 4.1. i have completed one simple problem in heat transfer. the model dimensions is 0.5m*0.05m*0.05m.i have applied the temperature on one end.the opposite end is insulated. i did solve it with fine results.but i want to see how much amount of temperature entered into the boundary and dissipated amount of temperature...and i also want split the geometry after simulation...possible to see inside of geometry..



Thanking you
parma

0 Replies Last Post 22 déc. 2011, 04:20 UTC−5
COMSOL Moderator

Hello shhtr hthas

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.