Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

moving mesh

Posted 26 mars 2012, 11:29 UTC−4 Fluid & Heat Version 4.2a 0 Replies

Ali Kohanzadehmaranlou
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

Im trying to simulate the flow pattern of steel fluid in the Ladle in the casting in 2D ( the attached file is what i did) . But i encountered a problem which said that "Failed to find consistent initial values. Last time step is not converged."
i want to use moving mesh to show the drainage of ladle. i defined upper wall as an inlet and i set the inlet velocity to zero.

would you please help me to solve this problem.

thanks


Attachments:

0 Replies Last Post 26 mars 2012, 11:29 UTC−4
COMSOL Moderator

Hello Ali Kohanzadehmaranlou

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content