Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

the domain of fluid

Please login with a confirmed email address before reporting spam

Hi,
I am using the Conjugate Heat Transfer Model to model a structure with water cooling. I imported the solidworks drawing file to COMSOL. My question is what is the easiest way to define the domain of the fluid for the structure? The fluid region wasn't previously defined and the shape of the cooling pipe is very complicated.
Please help. Thanks a lot.

2 Replies Last Post 22 mai 2012, 19:01 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 19 mai 2012, 03:38 UTC−4
Hi

You hve in 4.2a a geometry caps option to close a pipe entry if it has a continuous and well behaved entry boundary, the same for the exit.
Try it out

--
Good luck
Ivar
Hi You hve in 4.2a a geometry caps option to close a pipe entry if it has a continuous and well behaved entry boundary, the same for the exit. Try it out -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 22 mai 2012, 19:01 UTC−4
Hi,
Thanks a lot!
Hi, Thanks a lot!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.