Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

when we do the tensile stress simulation, why we have to select the materials and power?

Please login with a confirmed email address before reporting spam

In recent days, I saw many videos about comsol tensile simulation.

All the people applied specific power and materials to their structure.

So I followed it and I get the result below.

But, when I changed the material or tensile power, all the results showing the same result.

(It only shows the distribution of the stress.)

So, why people select the material and power?



0 Replies Last Post 4 mai 2021, 03:32 UTC−4
COMSOL Moderator

Hello Myounghyun Lee

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.