Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Random surface roughness

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


Hi, I went through the blog of generating random surface roughness on cylinder and was able to get that successfully. However, when I am trying to get the desired dimensions, the figure is getting messed up. What parameters are to be changed to vary the diamter and length of the cylinder.



0 Replies Last Post 14 févr. 2022, 12:46 UTC−5
COMSOL Moderator

Hello Inderjot Kaur

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.