Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Joule Heating + Skin effect

Please login with a confirmed email address before reporting spam

Hi to all,

I want to simulate the group effect of skin effect and Joule heating in a conductor. So I built a simple model of a conducting block and used Magnetic and Electric Fields (mef) and Heat transfer in Solids module. The frequency domain analysis solves nicely and I am able to get a plot of mef.Qe (EM power loss density) with the power losses concentrated on the edge, as it should be.

But I am unable to use this calculated EM power density in the Heat transfer module. I used Heat source option, but the structure doesn't seem to heat up if I use prepared electromagnetic general source options or if I type in mef.Qe as a User defined General source.

Any tips will be greatly appreciated.

Best regards
Matija

0 Replies Last Post 24 oct. 2012, 03:18 UTC−4
COMSOL Moderator

Hello Matija Podhraski

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.