Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cut point 3D analysis on applied loads

Posted 27 sept. 2023, 03:16 UTC−4 Version 5.6 0 Replies

Miya Sensor Designing
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have done a piezoelectric simulation and have added a Cut Point 3D in geometry. Once i compute the solutions I am able to plot the derived variables result like electric potential on that particular 3D point, but I am unable to graph the applied loads (obtained from initial conditions) to plot applied loads and generated potentials in one single 1D graph. For reference my study is time domain and I am applying a dynamic force over my piezoelectric structure,

0 Replies Last Post 27 sept. 2023, 03:16 UTC−4
COMSOL Moderator

Hello Miya

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content