3D Transformer Modeling

Please login with a confirmed email address before reporting spam

Hello everyone!

I am modeling an oil immursed transformer with practical dimensions and design to simulate short circuit test in order to find the electromagnetic forces on the coils. I am using BH curve for the core and "Coil" feature to model both HV and LV coils.

I am facing following issues: 1- Magnetic flux density in core is exceeding the saturation value, even when the coil currents are normal. 2- There is no functionality to add layers in the coils, only number of turns. How can I model my coils? HV coil is a strip with cross-sectional area of 1.65-by-4.5 mm2 with 24 layers and 87 turns in each layer (total turns = 2088). Onthe LV side, I have foil with 1.6-by-455 mm2 with 14 layers and obviously 1 turn in each layer.

I have tried changing every parameter in the magnetic field nodes but I am stuck with these problems. Kindly guide me through this. I would really appreciate some positive response.

Thanks.


0 Replies Last Post 6 mars 2024, 11:26 UTC−5
COMSOL Moderator

Hello Muhmmad Usman Anjum

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.