Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Establishing force-free constraint during current diffusion

Please login with a confirmed email address before reporting spam

I am trying to model the diffusion of current from an axisymmetric conductor into a surrounding antisymmetric conductor of differing conductivity. I would like to observe the diffusion of both axial currents and in-plane currents.

I model the diffusion of the azimuthal currents using the "Azimuthal Induction Currents, Vector Potential" application mode from the AC/DC module. The in-plane current diffusion is modeled using the "Meriodonal Electric and Induction Currents, Potential" application mode. Everything is 2-D axisymmetric. Run individually, both of these modes diffuse the current as expected.

My problem is that I need to couple the two modes by enforcing the force free constraint:
B = C*J
where B is the magnetic field, C is s constant, and J is the current density. This says that the current flows along the magnetic field lines, so there is no Lorentz force.

I have no idea how to enforce this constraint to couple the two application modes (I am fairly new to Comsol for anything beyond simple electrostatics problems). If anyone can offer advice, it is greatly appreciated.

Thanks,
Nick


0 Replies Last Post 30 juil. 2010, 14:00 UTC−4
COMSOL Moderator

Hello Nicholas Eidietis

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.