Centre d'apprentissage

Course:

Performing Optimization in COMSOL Multiphysics

Using Optimization Studies to Perform Parameter Optimization


In Part 4 of this course on optimization, we revisit the Optimization of a Tuning Fork tutorial model introduced in Part 3. Using this model, we demonstrate the entire process of adding, setting up, and computing an optimization study. Our objective throughout the demonstration is to find the appropriate length for the prongs of the tuning fork so that the first resonance is close to 440 Hz. You can follow along with the demonstration by downloading the cleared tuning fork MPH-file attached to this article.

Following this, we present a new example model to demonstrate how to perform parameter optimization on a beam. The objective is to find the optimal geometry by moving a point, which is defined through parameters, in order to remove material from the beam and minimize its weight without violating a displacement constraint when the beam is subject to a distributed load. The demo begins with the forward model already set up; you can download it here and use it to follow along with the rest of the guided demonstration.


Further Learning

Learn from additional tutorial models that use the Optimization study to perform optimization by opening the Application Libraries window in the software and starting a search using the following syntax: @tag:opt.


Submit feedback about this page or contact support here.