Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

wick debinding in metal injection molding

Posted 23 avr. 2011, 05:20 UTC−4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 3.5a 0 Replies

Yosean Lin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi,guys
i try to study the binder forms liquid bridge in particles cause it can be remove
i chose two-phase level set and ALE mode. i make the binder flow out compact by capillary force
now problems are how do i make inlet boundary be time-dependent and should i add more mode's like navier-stokes equation? thank you
0 Replies Last Post 23 avr. 2011, 05:20 UTC−4
COMSOL Moderator

Hello Yosean Lin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content