Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Conductive Media DC and Electrostatics

Please login with a confirmed email address before reporting spam

Dear all,

I am very new to comsol so I am hoping for a pointer in the right direction

I am working in 3D with the following desired setup:

One cone (insulating properties) in contact with two cubes, one on each side (metallic properties) one cube has a potential of one volt, the other is a ground.

Now here is where I run into my issue is that I also wish to assign a charge density to the cone. From what I have gathered is that you can do this with the Electrostatics model.

So my question is how do I get the surface charge density into the Conductive Media DC model?

Thank you for any help!
~Chris

0 Replies Last Post 15 juil. 2009, 14:28 UTC−4
COMSOL Moderator

Hello Christopher Stiles

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.