Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cut line 3D – Data Set : Transient Analysis

Posted 23 sept. 2011, 04:37 UTC−4 Results & Visualization Version 4.2 0 Replies

Pini Tandeitnik
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I’ve defined a Cut Line 3D Data Set in my model.
The model is time dependent.

I would like to display in a 3D plot the signal changes during the simulation along the Cut line:
X axis – points along the cut line
Y axis – simulation time steps
Z axis – model signal value

How it cab be done in COMSOL 4.2

Thanks,

Pini



0 Replies Last Post 23 sept. 2011, 04:37 UTC−4
COMSOL Moderator

Hello Pini Tandeitnik

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content