Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

parametric study

Posted 20 févr. 2012, 10:45 UTC−5 Fluid & Heat, Computational Fluid Dynamics (CFD), Studies & Solvers Version 4.2a 3 Replies

Siva Kumar Manickam
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone
I want to have parametric study of two variables each having different range of values.
How can I include such thing in a timedependent study?

Thanks in advance.
Siva
3 Replies Last Post 20 févr. 2012, 12:10 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 févr. 2012, 11:27 UTC−5
Hi

check the doc about the "Parametric Sweep" node, you add it manually before your time dependent series. Then check the doc again about how to best handle multiple parameters

--
Good luck
Ivar
Hi check the doc about the "Parametric Sweep" node, you add it manually before your time dependent series. Then check the doc again about how to best handle multiple parameters -- Good luck Ivar
Siva Kumar Manickam
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 févr. 2012, 12:04 UTC−5
Thanks dr. Ivar.
I got from the doc.
Actually I wanted to use full multiparameter sweep (solve for the first value of the first parameter combined with all values of the second parameter, then the second value of the first parameter combined with all values of the second parameter, and so on).

This was not working properly with all the possible settings.

But actually an earlier parameteric setting was lying in the job configuration giving wrong combinations. I deleted the study, saved closed and added new study I got now without any problem

Thanks again.

Thanks dr. Ivar. I got from the doc. Actually I wanted to use full multiparameter sweep (solve for the first value of the first parameter combined with all values of the second parameter, then the second value of the first parameter combined with all values of the second parameter, and so on). This was not working properly with all the possible settings. But actually an earlier parameteric setting was lying in the job configuration giving wrong combinations. I deleted the study, saved closed and added new study I got now without any problem Thanks again.
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 févr. 2012, 12:10 UTC−5
Hi

read carefully the way the parameters are stacked, it's not 100% obvious the first time ;)

--
Good luck
Ivar
Hi read carefully the way the parameters are stacked, it's not 100% obvious the first time ;) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content