Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
If two blocks overlap, are they considered continuous and a union?
Posted 22 févr. 2012, 20:08 UTC−5 Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I have two blocks that both have the same dimension that i want to sweep. The two blocks overlap. Are they considered a union during simulation?
Thanks.
-Stacey
I have two blocks that both have the same dimension that i want to sweep. The two blocks overlap. Are they considered a union during simulation?
Thanks.
-Stacey
1 Reply Last Post 23 févr. 2012, 15:55 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
if in the geometry section you have two objects (volume sin 3D, surfaces in 2D) that overlap, and you use Finish union mode, these will be united into 3 entities (domains in this case), with common continuity type boundaries
If you use Finish assembly mode, you will end up with 2 entities that overlap (which might not be physically correct, all depends what you are after), and your physics have no default continuity boundary conditions. Yo umust defien your pairs yourself and define the physics linking them manually
--
Good luck
Ivar
if in the geometry section you have two objects (volume sin 3D, surfaces in 2D) that overlap, and you use Finish union mode, these will be united into 3 entities (domains in this case), with common continuity type boundaries
If you use Finish assembly mode, you will end up with 2 entities that overlap (which might not be physically correct, all depends what you are after), and your physics have no default continuity boundary conditions. Yo umust defien your pairs yourself and define the physics linking them manually
--
Good luck
Ivar