Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

FEAST electrode placement

Posted 6 avr. 2021, 03:54 UTC−4 Electromagnetics Version 5.4 3 Replies

Abdulrahman Alduraywish
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there, just wondering how I can define a rectangular shape on head model so that the rectangle is rotated and stitched to the skin at the same time? thanks

Attachments:

3 Replies Last Post 14 avr. 2021, 21:57 UTC−4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 6 avr. 2021, 08:40 UTC−4

Hello Abdulrahman,

If I understand correctly, what you want to do is quite similar to what is discussed in this Discussion Forum thread.

Best regards,

Jeff

-------------------
Jeff Hiller
Hello Abdulrahman, If I understand correctly, what you want to do is quite similar to what is discussed in [this Discussion Forum thread](https://www.comsol.com/forum/thread/283761/diverter-strip-for-aircraft-radome?last=2021-03-29T13:03:52Z). Best regards, Jeff
Abdulrahman Alduraywish
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 6 avr. 2021, 19:26 UTC−4

Hi Jeff,

yes, It is.

Thanks, Abdul

Hi Jeff, yes, It is. Thanks, Abdul
Abdulrahman Alduraywish
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 14 avr. 2021, 21:57 UTC−4

Hi Jeff,

I went through the model you have provided, but how I can implement this on a head subject that has been imported to COMSOL as mesh. When I try to create block, the mesh has to be deleted.

Regards, Abdul

Hi Jeff, I went through the model you have provided, but how I can implement this on a head subject that has been imported to COMSOL as mesh. When I try to create block, the mesh has to be deleted. Regards, Abdul

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content