Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

eddy current analysis

Please login with a confirmed email address before reporting spam

I am attempting to model a permanent magnet bearing with an eddy current damper in the stator using the AC/DC module. However, when plotting the values for Fx and Fy, I'm encountering significantly low results. I have attached the model.



0 Replies Last Post 2 avr. 2024, 01:36 UTC−4
COMSOL Moderator

Hello Supreeth D K

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.