Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Merge two mesh
Posted 8 août 2010, 07:05 UTC−4 Mesh Version 3.5a 2 Replies
Please login with a confirmed email address before reporting spam
Hello Mashallah Rezakazemi
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I've got a similar problem. I would like to merge two meshes imported from Matlab in Comsol 3.5a.
At p. 132 of Matlab Interface Guide, it is explicitly written "Importing a mesh from a file removes all geometry objects from the current geometry".
Therefore, I saved each imported mesh into a separate .mph file (I payed attention to create geometry from mesh before saving each file). Then, I used File -> Merge Component, but it doesn't work.
Any tip or suggestion to overcome this difficulty?
Many thanks in advance!
Best Regards,
PM
Please login with a confirmed email address before reporting spam