Articles techniques et présentations

Recherche rapide

Ressources

Livres Blancs

Bridging the Terahertz Gap
Modeling the Lithium-Ion Battery
Protection contre la Corrosion
Modélisation des batteries
Modélisation et Simulation dans le développement des piles à combustible
Modélisation thermique des petits satellites
Analyse électro-vibroacoustique d'un transducteur à armature équilibrée

Reacting Flows in Industrial Duct-burners of a Heat Recovery Steam Generator

G. Petrone[1], G. Cammarata[1], S. Caggia[2], and M. Anastasi[2]
[1]Department of Industrial and Mechanical Engineering, University of Catania, Catania, Italy
[2]Engineering Maintenance - ISAB Energy Services, Priolo Gargallo, Italy

Publié en 2008

In this study, COMSOL Multiphysics is applied in order to simulate reacting flows for duct burner systems arranged in the post-firing section of a Heat Recovery Steam Generator of a combined cycle power plant.

Two- and three-dimensional simulations are carried out in order to investigate on operative conditions mainly responsible of duct burners overheating.

The results are obtained for several chemical compositions of the supplied fuel and for several values of the fuel mass flow rate incoming inside the control volume.

Téléchargement

Petrone_pres.pdf - 5.96MB
Petrone.pdf - 1.74MB