Ici vous trouverez les présentations issues des Conférences COMSOL à travers le monde. Réalisées par des utilisateurs de COMSOL Multiphysics, ces présentations explorent tous les domaines actuels d'innovation. Les applications couvrent pratiquement tous les secteurs industriels et impliquent des phénomènes électriques, mécaniques, fluidiques et chimiques. Utilisez la recherche rapide pour trouver les présentations les plus intéressantes dans votre domaine d'intérêt.

Evaluation of COMSOL as a Tool for Pinpointing Moisture Entering Locations From Inside Surface Moisture

J. van Schijndel
Eindhoven University of Technology, Eindhoven, Netherlands

The location and nature of the moisture leakages are sometimes difficult to detect. Moreover, the relation between observed inside surface moisture patterns and where the moisture enters the construction is often not clear. The objective of this paper is to investigate inverse modeling techniques as a tool for the detection of moisture leakage locations in building constructions from inside ...

Optimization Of The Collection Of Sprays By An Enhanced Electronic Sensor

J. Berges[1], B. Barelaud[1], I. Niort[2], and J.L. Decossas[2]
[1]XLIM, Limoges, France
[2]Université de Limoges, France

We propose the study of an electronic sensor allowing the collection of sprays in free space. The detector consists of three elements: a photodiode situated in the center of the structure to which is applied a bias voltage, an aluminum ring which referenced to a voltage higher than that of the photodiode and an insulating material disk (polyvinyl chloride). The total size of the structure is ...

Simplifying A Model Of Short Subsequent Sections Containing A Common Detailed Cross-Section

J. Krah
AkerSolutions, Fornebu, Norway

In COMSOL Multiphysics it is possible to implement and simulate several independent models in parallel. This can be meaningful when the different models are coupled to each other by some kind of interaction. If a part of the geometries is identical in all models, this part can be reduced in that it is implemented in only one of the geometries. In the other geometries only its solution towards ...

Experimental and Numerical Fluid Flows Study on a X-Millichannel

C. Wolluschek[1], F. Etcheverry[2], M. Cachile[2], and J. Gomba[3]
[1]Mecánica de Fluidos e Ingeniería Térmica, Centro tecnológico Cemitec, Noáin, Navarra, Spain
[2]Grupo de Medios Porosos, Facultad de Ingeniería, UBA, Buenos Aires, Argentina
[3]Instituto de Física Arroyo Seco, UNCPBA, Tandil, Argentina.

In this work, a COMSOL model that predicts velocity and concentration fields inside an X-shaped millichannel (4 mm diameter) is developed. Water and a ink low concentration are injected simultaneously in the two inlets of the device. The mass transfer problem is solved by a Fickian model (solute concentration is low compared with the solvent). The parameters in this study are: initial inlet mass ...

Analysis Of The Design Criteria For Ancient Greek And Roman Catapults

K.M. Paasch
Center for Product Development, Mads Clausen Institute, South Danish University, Denmark

This paper will give a short overview of use of COMSOL Multiphysics for analyzing ancient Greek and Roman catapults with the main focus on the energy storing torsion springs. Catapults have been known and used in the Greek and Roman world from around 399 BC and a fully standardized design for powerful torsion catapults emerged around 270 BC, based on one basic factor, the diameter of the torsion ...

181 - 185 of 185 First | < Previous | Next > | Last