- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
COMSOL Conference 2025 Proceedings
Recueil d'articles, de poster et de présentations acceptées par le Comité de programme
À la conférence COMSOL 2025, des ingénieurs, des chercheurs et des scientifiques du monde entier ont présenté leur utilisation de la modélisation et de la simulation dans tous les grands secteurs d'activité et dans le monde universitaire. Utilisez l'outil de recherche rapide pour trouver une présentation spécifique ou filtrez par sujet ou par lieu d'événement.
Lithium ion battery electrodes are porous composite film made up of two or three different types of solid material. Typically using the fabrication of the electrode, the solid powders (active material, binder and in most cases a conductive active) are dispersed in a solvent like NMP and ... En savoir plus
In this, FEM simulation of the interdigitated electrodes (IDEs) device using COMSOL Multiphysics® is presented. In this study, the effect of meshing sequence on the performance of IDEs device was evaluated using normal as well as adaptive mesh refinement. The key parameters such as of ... En savoir plus
Arches being one of the most aesthetic and stable form of structural elements, have been constantly used since hundreds of years in various form of constructions be it buildings, bridges or any other structural system. Though, common use of reinforced concrete framed structures has ... En savoir plus
Numerical investigations of magnetorheological elastomer millimeter-scale robots capable of undulatory swimming under magnetic body torques are realized for the first time in low Reynolds number condition using AC/DC, CFD, Structural Mechanics modules in COMSOL Multiphysics®. The ... En savoir plus
Active fluid jet polishing is a sub-aperture polishing process used in the optical fabrication of complex surfaces. Correction of surface irregularities during the polishing process is a challenging process. Quality of optical surface depends on smoothing action during fine and ... En savoir plus
This paper presents numerical investigation of electronic thermal control using heat sink for integrated circuit (IC) chip cooling under forced convection in a horizontal channel. Steady state, three dimensional, incompressible, laminar forced convection cooling of chip attached with ... En savoir plus
Renewable energy sources such as solar and wind are intermittent in nature. Their effective utilization requires efficient, low cost energy storage systems to complement energy harnessing systems. The rechargeable flow batteries have emerged as the most suitable candidates due to their ... En savoir plus
Surface Acoustic Wave devices are classic examples of Micro Electro Mechanical Systems (MEMS). These devices basically utilize inter-digitated electrodes (IDE) and a piezoelectric layer deposited over a substrate. The input IDT is supplied with alternating voltage and because of this, ... En savoir plus
