Articles techniques et présentations

Introduction Velocity profiles in liquid films flowing over rotating conical surfaces are of considerable interest in industry. The efficiency of important process equipment, such as spinning cone columns, fluid degassers, centrifugal disc atomizers, centrifugal film evaporators, and ... En savoir plus

This study presents a oil-gas two-phase linear flow EMH model using COMSOL Multiphysics simulator. Special attention is focused on reservoirs with characteristics for which steam injection is not attractive or feasible such as low permeability, thin-zone, and extra-heavy oil reservoirs. ... En savoir plus

The quality of coatings obtained by means of thermal spraying depends strongly on the mechanism of the interaction between the molten droplets and the surface to be covered. The aim of the present study is to simulate the impact of a droplet onto a substrate, in order to have a good ... En savoir plus

The understanding of the tracer migration in two-phase porous media systems and its reaction over the fluid-fluid interfaces is a challenging task important for a number of engineering applications, e.g. oil recovery, carbon capture and storage in geological reservoirs, remediation ... En savoir plus

Modeling and simulation softwares are very useful tools when we have to analyse and understand the different phenomena occurring during metal foams processing, because several simultaneous physical mechanisms have to be accounted for. In this work we use Comsol Multiphysics 4.2 to model ... En savoir plus

The contrast between hydro-mechanical behavior of the rock matrix and fracture network systems results in flow partitioning between fracture and matrix systems which is affected by the In-situ stress regime. Fracture flow, Darcy law and free and porous media flow physics interfaces of ... En savoir plus

To maintain same droplet size across parallel devices, new break-up strategies based on geometry are been studied. In this work, we model a geometrically-set droplet generator, in which the droplet break-up occurs by a block and break mechanism. In other words when the disperse phase ... En savoir plus

In this study we investigate the heat and mass transfer in a porous media with phase change. The liquid fluid is injected from one side and heated from the other side, where it leaves the porous material in a gaseous state. Dominant forces are capillary interactions and two-phase heat ... En savoir plus

The primary motivation of this work was to develop flow models in porous media with fractal properties to represent the anomalous behavior observed in some pressure tests in naturally fractured reservoirs. En savoir plus

As an effective method to cope with green-house gas emission, and to enhance oil recovery, injection of carbon dioxide into oil reservoirs has obtained increasing attentions. The flooding process involves complex phase behavior among oil, brine and CO2, and geochemical reaction between ... En savoir plus