Articles techniques et présentations

COMSOL Multiphysics® software is used to explore the impact of distributor width on the film thickness, and the resulting sensitivity of overall thermal efficiency in a plate and frame triple-effect evaporator. A stable film is crucial to maintain a minimum wetting rate, to circumvent ... En savoir plus

The paper outlines a two-dimensional computational methodology and presents results for laminar/laminar condensing flows inside mm- scale ducts. The methodology has been developed using MATLAB/COMSOL platform and is currently capable of simulating film-wise condensation for steady and ... En savoir plus

A laboratory-scale fluorine reactor was simulated with COMSOL Multiphysics®. This model employs fundamental fully coupled electron-, heat-, mass- and momentum transfer (two-phase) equations to deliver a transient model of the above-mentioned reactor. Quasi-steady-state results were ... En savoir plus

The interaction of a single particle in straight rectangular channel in laminar flow is modelled explicitly using the set of Navier Stokes equation for the fluid motion and Newton momentum equation for the particle motion in Cartesian coordinate system. The evaluation of integral force ... En savoir plus

In the conference we bring together a community that is scientifically diverse in an event about the use of COMSOL Multiphysics. Oral and poster presentations highlight achievements in multiphysics modeling and simulations using COMSOL. En savoir plus

NASA and the Department of Defense have interest in the development of satellites which are several orders of magnitude smaller than those currently in use. These ‘nanosats’ will require new propulsion systems to offer precise thrust and impulse-bit characteristics on the order of 10 ... En savoir plus

This paper presents steady and unsteady computational results obtained from numerical solutions of the full two-dimensional governing equations for annular internal condensing flows in a channel. This is achieved by tracking the “sharp” interface while solving the flow fields using ... En savoir plus

Waterflooding is widely used in secondary oil recovery. The physics is described by the model of two-phase flow in porous media. The aim of the present work is to implement this model in COMSOL Multiphysics and to simulate the process of waterflooding. It is analyzed in two dimensions. ... En savoir plus

In this conference we have brought together a community that is scientifically diverse in an event that allows for inspiring contacts about the use of COMSOL Multiphysics. It is an event to connect with the Spanish and Portuguese COMSOL Multiphysics users and participate in training ... En savoir plus

A flow and transport model in porous media was implemented in COMSOL Multiphysics® software to simulate, analyze and interpret Microbial Enhanced Oil Recovery (MEOR) processes at core scale under laboratory conditions. The flow model is biphasic and is based on the oil phase pressure ... En savoir plus