Articles techniques et présentations

In-situ electrical heating technologies are among the most recent technologies used for bitumen recovery from tar sand and oil shale. These technologies have limited environmental impact because there is little disturbance of the land, and water and solvents are not used. Two-phase ... En savoir plus

Introduction Velocity profiles in liquid films flowing over rotating conical surfaces are of considerable interest in industry. The efficiency of important process equipment, such as spinning cone columns, fluid degassers, centrifugal disc atomizers, centrifugal film evaporators, and ... En savoir plus

The blast furnace hearth drainage constitutes a major part of the blast furnace operation. Especially, keeping track of the iron and slag levels is crucial to adapt the tapping strategy. The operational target is usually not only to empty the blast furnace as far as possible but also to ... En savoir plus

Wettability affects two-phase displacements in porous media by determining the microscopic distribution of fluids in pore spaces. The impact of wettability on transport properties at macro-scales has been widely addressed in literature; however a deeper understanding of wettability ... En savoir plus

Considering a liquid drop in relative movement with respect to the air flow at uniform velocity, the liquid will be driven to the surface by the viscous friction. Internal vortices will appear inside the drop. This problem has already been studied in fluid mechanics and is well known as ... En savoir plus

Verification of the codes applied for assessment of the long-term repository safety is typically one of the quality assurance requirements demanded by regulatory bodies, in the disposal of radioactive waste. In this paper, an internationally organized benchmark exercise is presented, in ... En savoir plus

The efficiency and environmental impact of oil production become a principal challenge of energy producing companies. The improvement of existing and development of novel methods are often feasible within either a “new” physical framework (from the viewpoint of oil reservoir ... En savoir plus

Recent studies have been devoted to develop mathematical models to simulate the food processing using the porous media approach. The aim of this study is to simulate the microwave drying of osmodehydrated food by means of modeling the mass, energy and momentum transfer using the porous ... En savoir plus

COMSOL Multiphysics® software is used to explore the impact of distributor width on the film thickness, and the resulting sensitivity of overall thermal efficiency in a plate and frame triple-effect evaporator. A stable film is crucial to maintain a minimum wetting rate, to circumvent ... En savoir plus

Dilution’s issue during dry machining have raised the interest’s environmental researchers and engineers. In fact, the sampling of dust emitted during dry machining was a serious problem for air quality evaluation at the workplace. Furthermore, the best sampling of fine and ultrafine ... En savoir plus