- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
This paper presents the study and design of a new generation oven for PET blow-molding machines. The design faced several technical challenges such as: the temperature distribution in the critical areas, the sharp curvature radius, the high PET thermal inertia and the presence of ... En savoir plus
Gallium nitride (GaN) and its related nitride alloys with special physical properties are in technical areas of high interest. The growing of gallium nitride boules on non-native sapphire or silicon carbide requires complicated mechanisms of defect reduction in the lattice structure. ... En savoir plus
In many metallurgical processes metals are (heated and) stirred by an oscillating external magnetic field. The magnetic field induces electric currents in the metal and the currents interact with the magnetic field to create a force, the Lorentz force. For high frequencies induction only ... En savoir plus
A comparative study is done using optimized single axis accelerometer and dual axis and double gimbal accelerometers are designed with different cantilever beam types i.e. perforated, non perforated, spring type and cross spring type. The models are simulated to find the most sensitive ... En savoir plus
Large centrifugal compressors, which are commonly applied in the oil and gas and in the process industry, may fail due to vibrations of the impeller. These vibrations are induced by pressure pulsations in a compressor stage. These vibrations can be especially strong in so-called dense ... En savoir plus
For the SAFARI Imaging Spectrometer, part of the SPICA satellite payload, a Calibration Source is under development. Challenges in the design include the low cooling power (few mW) available at cryogenic temperatures. COMSOL Multiphysics® simulations were used extensively in the design ... En savoir plus
In the modern food industry one of the most important problems to face is to preserve products from deterioration: a widely used solution is the convective foods drying. Drying is based on a simultaneous transfer of both heat and water that takes place when dry and warm air flows around ... En savoir plus
INTRODUCTION Our group at ORNL started using COMSOL Multiphysics® software shortly after version 3.0 was released in the Spring of 2004. After 11 years and several releases, the application usage has grown along with number of licenses we are responsible for. This paper will broaden ... En savoir plus
Engineering design studies of the feasibility of conversion of the High Flux Isotope Reactor (HFIR) from high-enriched uranium to low-enriched uranium fuel are ongoing at ORNL as part of an effort sponsored by the U.S. Global Threat Reduction Initiative program. HFIR is a very high flux, ... En savoir plus
Solar radiation is a prominent contributor of energy in buildings, and can be transmitted directly into a building through opaque surfaces, but it can also be absorbed by building components (i.e. walls, roofs etc.). This study discusses the use and effect of ventilated facades, with an ... En savoir plus