Articles techniques et présentations

This paper describes a type of didactic material used when teaching electromagnetism. The purpose is to guide the students to verify the results of a Finite Element (FE) simulation using those obtained analytically. This procedure has shown to be of great help during their learning of ... En savoir plus

In our project, we propose an innovative software solution to the problem of electrical arcing risk prediction in high-voltage on-board electronic equipment intended for long-term self-contained use, e.g. in spacecraft conditions. It completely based on so-called “decomposition” approach ... En savoir plus

The recently developed technique Scanning Tunneling Microscopy in the Field Emission regime (STM FE) is based on the Russell Young's topografiner technology. The set-up is a no contacting device consisting of a sharp tip approached vertically to a conducting surface at variable distances ... En savoir plus

Due to the complexity of electromagnetic modeling, researchers and scientists always look for development of accurate and fast methods to extract the parameters of electronic interconnects and package structures. In this paper, we illustrate modeling of multiconductor interconnects in ... En savoir plus

This article describes the development of a bulk mode resonator which can be employed for detection of bio/chemical species in liquids.  The goal is to understand the mechanical and electrical properties of a bulk mode resonator device which exhibit high frequency resonance modes and Q ... En savoir plus

In this paper an electromagnetic solenoid actuator (EMVA) consisting of an upper and lower electromagnet, a linear moving armature and two preloaded springs is considered as a potential approach in Variable Valve Actuation (VVA) Systems for Internal Combustion Engines. In opposition to ... En savoir plus

In this paper simulation of the alternating current loss (AC loss) in a high temperature superconducting tape and a HTS cable having 4 layers of polygon conductors using COMSOL Multiphysics software has been reported. The simulation results for the single rectangular tape are verified ... En savoir plus

Outline of presentation: In electromagnetic technology applications the finite element method is very well suited for a wide range of problem types For many cases, in particular when inhomogeneous materials having complex properties are involved as well as when multiphysics couplings ... En savoir plus

A 3D model of a magnetic rotor both rotating and translationally moving at high-speed over a conductive guideway is modeled in steady-state using the convective A*-Φ formulation. The presence of the magnetic rotor (source field) is incorporated into the formulation via the boundary ... En savoir plus

MEMS resonators have been recently adopted in a wide variety of timing, sensing, and actuation applications. The ability to control the dynamics of resonance, namely the resonance frequency and quality factor of these resonators is crucial in achieving high precision performance within ... En savoir plus