- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
INTRODUCTION: Nuclear magnetic resonance (NMR) spectroscopy is a broadly used research technique that exploits the magnetic properties of atomic nuclei with non-zero spin in order to determine the physical/chemical properties of the molecules in which they are contained. However, NMR has ... En savoir plus
In electric distribution network, current and voltage measurement for metering, monitoring, and protection & control applications is done via instrument transformers (current and voltage transformers). These measurement devices are deployed during the construction phase of the ... En savoir plus
The use of Microwave/RF energy on cancer cells is explored for tumor ablation using medium power level ranging between a few Watts to about 50 Watts. In this research, low power levels, less than 100 mWatt, are used to evaluate the effect of this energy on Uveal melanoma cells by ... En savoir plus
Acoustic streaming (AS) describes a physical phenomenon where an oscillating sound emitter induces a steady fluid motion. Metal processing industry applies this treatment for grain morphology adjustments during the solidification of metal. Improvement and further development of this ... En savoir plus
Teledyne Marine developed a system for the long-range ocean acoustic tomography, which uses a tunable, high-efficiency sound resonator. The high-Q resonator tunes to match the frequency and phase of a reference frequency-modulated signal. The analysis of a high-Q resonant organ pipe with ... En savoir plus
Introduction: RFID system uses a Transponder and the near field communication (NFC) antenna and a matching circuit (Figure-1) in which at least latter two must be optimally designed for a higher efficiency. Typically, RFID antennas are flat inductive coils with 2 to 4 turns and are ... En savoir plus
Surface and solution kinetics for redox systems can be reliably and accurately studied using hydrodynamic electrochemical methods, particularly a rotating disk electrode (RDE). The RDE consists of a disk electrode usually made of glassy carbon or noble metals imbedded in a rod of ... En savoir plus
This paper utilizes lumped circuits equivalent and pressure acoustics to simulate the behavior of a PA loudspeaker in order to improve its design. En savoir plus
The calculation of additional losses in induction machines is a challenging task. In skewed motors, a part of these losses is connected to the phenomena of inter-bar currents. Inter-bar currents flow between adjacent bars through the rotor lamination. Since they are aligned perpendicular ... En savoir plus
A good approximation of rough surfaces and their random behaviour is very important in some engineering problems. Fractal modelling provide an alternative to generate rough surfaces based in statistically self-similar non-Euclidean geometries, as seen in [Fig. 1]. Through a frequency ... En savoir plus
