- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
The Geoenvironmental Engineering Group of the University of Castilla-La Mancha is developing a computational tool, M4B, for describing the influence of environmental loads on the deformation behavior of soils and its interaction with building foundations. This tool comprises a set of ... En savoir plus
A wide variety of near-field optical phenomena such as apertureless near-field scanning microscopy (ANSM) at optical and terahertz (THz) regimes and surface enhanced Raman scattering relies on the electric field enhancement at the end of a sharp tip. Achieving and controlling this ... En savoir plus
Lithium-sulphur (Li-S) batteries have the potential to surpass the energy storage capability of Li-ion batteries due to their high theoretical gravimetric energy density of 2700 Wh/kg. However, the processes which drive the system behaviour are much more complex than those in a Li-ion ... En savoir plus
Reactive transport models (RTM) that couple physical and chemical processes are commonly used to solve a large variety of problems in the environmental industry. There are a series of codes designed to solve this kind of problems. However, their use requires typically much effort due to ... En savoir plus
Encapsulation is an established technique to protect sensitive materials from environmental factors such as oxygen and light. Nutritionally beneficial fatty acids like omega 3 fatty acids are susceptible to oxidation and are therefore encapsulated by drying an oil in water emulsion. It ... En savoir plus
The results of two thermal response tests recently performed on two vertical borehole heat exchangers (BHEs) are presented. The BHEs have the same cross section and a depth of 100 m and 120 m respectively. The evaluation of the thermal properties of the ground and grout are performed by ... En savoir plus
Because of the complex nature of geomaterials and presence of solid and fluid within a single system, it is crucial to consider all the physics involved within the geomaterial system. A fully coupled thermo-hydromechanical model is developed. The model consists of a three-phase flow ... En savoir plus
This paper deals with the numerical experiments for early prediction of muffler performance at the design stage. In this experiment a Reactive Muffler is developed and validated numerically compared to traditional built and test process. En savoir plus
Cowpea seed is a pulse which is very rich in vital micronutrients but also in anti-nutritional factors such as α-galactosides (verbascose, stachyose and raffinose) that can cause digestive disorders after consumption. The objective of this work was to identify the transport and ... En savoir plus
A model of an office room was created in the COMSOL Multiphysics® software to simulate heat transfer and study the impact of siting a mass of phase change material (PCM) in a room to increase thermal comfort. This study determined that incorporating the selected PCM, butyl stearate, in ... En savoir plus