- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
A 2-D unsteady viscous flow around two cylinders is studied by numerical solutions of the unsteady Navier-Stokes equations with a finite element formulation using COMSOL Multiphysics®. The results of a numerical investigation of the Strouhal frequencies of two identical, stationary, ... En savoir plus
High intensity discharge lamps can experience flickering and even destruction, when operated at high frequency alternating current. The cause of these problems has been identified as acoustic resonances inside the lamp’s are tube. Here, a finite element approach for the calculation ... En savoir plus
The present paper describes the results of a Finite Element Model used to analyze sound propagation in lined ducts. By means of a numerical model it was possible to predict the insertion loss inside rectangular lined ducts in a frequency range from 250 Hz to 4000 Hz. The model was ... En savoir plus
This paper deals with the numerical experiments for early prediction of muffler performance at the design stage. In this experiment, a Reactive Muffler is developed and validated numerically compared to traditional built and test process. En savoir plus
High power Lower-Hybrid RF waves injected at in a Tokamak plasma can strongly modify the edge plasma. This is caused by ponderomotive forces pushing charged particles in an inhomogeneous oscillating electromagnetic field towards weaker field areas. On the Alcator C-Mod Tokamak, edge ... En savoir plus
Introduction Present paper gives a comparison of the Upperconvected Maxwell (UCM) and the Oldroyd-B model for the calculation of dissipation in high shear-rate cases of viscodampers. When polymeric liquid is considered that part of energy that is irreversible can not be calculated in the ... En savoir plus
The application of an oscillating magnetic field on the high-power full-penetration laser beam welding process of a 20 mm thick stainless steel plate was numerically and experimentally investigated. In the simulations, three-dimensional heat transfer and fluid dynamics as well as ... En savoir plus
In this paper, the effects of roughness in the surfaces of the plates caused due to nonuniform etching during their release and/or due to defects in the original wafer on the capacitance in RF-MEMS parallel plate varactors are analyzed. Capacitance extraction due to surface roughness has ... En savoir plus
A growing demand is recently emerging of sensors to be integrated in the concrete in order to measure some critical parameters, such as humidity and temperature and the internal pressure of the material. For example, by monitoring the pressure in various strategic points of the structure ... En savoir plus
In this paper, the effect of a crack to the flow-induced vibration characteristics of supported pipes is investigated based on vibration method. In order to estimate the crack location and depth in the pipe, we need to utilize the variation of the difference between the natural ... En savoir plus