- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
Laser-induced photovoltage in ferromagnetic thin films is often explained by magneto-thermoelectric effects such as the anomalous Nernst effect (ANE). ANE appears when thermal gradients interact with magnetization. While power loss in flat films can be estimated analytically, numerical ... En savoir plus
This work presents a comprehensive modeling and validation study of MEMS-based infrared (IR) emitter chips using a neural network-assisted inverse modeling approach in COMSOL Multiphysics. Starting from a single baseline chip geometry, a simulation model was developed that captures the ... En savoir plus
This work addresses the critical challenge of accurately determining the inner states of three-phase electric smelting furnaces, commonly used in ferro-alloy and silicon production. Gaining insights into these internal states is crucial for optimizing furnace performance, energy ... En savoir plus
Successive studies on graphene, reactive-edge graphene, and pore functionalized graphene were conducted throughout the use of the extended capabilities of COMSOL Multiphysics® modules, modeling and simulating the activation of functionalized building-blocks made of graphene and C- ... En savoir plus
The Geoenvironmental Engineering Group of the University of Castilla-La Mancha is developing a computational tool, M4B, for describing the influence of environmental loads on the deformation behavior of soils and its interaction with building foundations. This tool comprises a set of ... En savoir plus
A dual axis MEMS seismometer targeted for building monitoring system has been simulated for a full scale of ±5g acceleration. The design uses the capacitive effect for vibration sensing. This comb drive capacitive MEMS seismometer consists of 8 springs with two proof masses. The device ... En savoir plus
The problem of storage, and release of thermal energy is an important challenge in various industrial fields. Several systems for thermal energy storage exist like phase change materials (PCM) and thermochemical storage [1]. The first system usually addresses short term storage (day ... En savoir plus
Pioneering Computational Models for the Built Environment Energy performance is becoming more important in the build environment. With better insulated buildings, the possibility of moisture problems and thermal bridges increases. There for, it is not only important to determine the ... En savoir plus
Temperature measurements of the subsurface are available due to hydrocarbon exploration in the project area, where the average drilling depth is about 2-4 km and the deepest well reaches about 8.5 km. Since the data is heavily uneven distributed, standard interpolation techniques did not ... En savoir plus
In order to predict, improve and meet a certain set of performance requirements related to the indoor climate of buildings and the associated energy demand, building energy simulation (BES) tools are indispensable. Due to the rapid development of FEM software and the Multiphysics ... En savoir plus