Articles techniques et présentations

Recherche rapide

Ressources

Livres Blancs

Voyez comment la modélisation et la simulation sont utilisées par les industries La modélisation et la simulation multiphysiques pilotent l'innovation dans tous les grands secteurs d'activité et dans le monde universitaire — comme en témoignent les nombreuses utilisations présentées dans des articles et des posters techniques présentés par des ingénieurs, chercheurs et scientifiques à la Conférence COMSOL chaque année. Inspirez-vous des récents proceedings réunis ci-dessous, ou, pour trouver les présentations les plus intéressantes dans votre domaine d'intérêt, utilisez la recherche rapide.

Consultez les proceedings de la Conference COMSOL 2024

Toutes

Boston 2025

Terme recherché:

velocity field

Study Of An Axial Injection Torch

K. Gadonna[1], O. Leroy[1], C. Boisse-Laporte[1], P. Leprince[1], and L.L. Alves[2]
[1]LPGP, CNRS/UPS, Orsay, France
[2]IPFN/IST, Lisboa, Portugal

The axial injection torch (AIT) produces high-density plasmas by coupling microwave power to a flowing gas. The plasma is imposed by defining its electron density and temperature whose maximum are given by optical emission spectroscopy diagnostics. Our study of an AIT with COMSOL ... En savoir plus

Modeling of a DBD Reactor for the Treatment of VOC

L. Braci[1], S. Ognier[1], and S. Cavadias[1]
[1]Laboratoire de Génie des Procédés Plasmas et Traitements de Surfaces, Ecole Nationale Supérieure de Chimie de Paris, University Pierre et Marie Curie, Paris, France

Non-thermal plasma, generated in atmospheric pressure discharges, has been investigated in our laboratory in order to treat highly diluted (300 ppm to 1000 ppm) volatile pollutant. The collision of electrons created in the discharge with atmospheric air, leads to the formation of ... En savoir plus

COMSOL Analysis of Acoustic Streaming and Microparticle Acoustophoresis

H. Bruus[1], P.B. Muller[1], R. Barnkob[1], M.J.H. Jensen[2]
[1]Technical University of Denmark, Kongens Lyngby, Denmark
[2]COMSOL, Kongens Lyngby, Denmark

We have simulated the ultrasound-induced acoustophoretic motion of microparticles suspended in an aqueous solution. The full first-order thermoviscous acoustics equations have been implented on a rectangular microfluidic 2D domain excited with an ultrasound field tuned to resonance near ... En savoir plus

Claus Process Reactor Simulation

J. Plawsky[1],
[1]Rensselaer Polytechnic Institute, Troy, NY, USA

A model was developed to simulate the reaction, concentration field, flow field, and temperature distribution inside a Claus reactor for converting hydrogen sulfide to sulfur. The model considered two ideal reactors, a continuous stirred tank reactor and a plug flow reactor. As expected, ... En savoir plus

Thermo-Fluid Dynamics of Flue Gas in Heat Accumulation Stoves: Study Cases

D. Rossi[1], P. Scotton[1]
[1]University of Padova, Department of Geosciences, Padova, Italy

The research aims to clarify some aspects of the thermo-fluid dynamics of woody biomass flue gas, within the twisted conduit inside the heat accumulation stoves, and exposes also some analysis about the heat transport and heat exchange processes. The high temperature flue gas flows in ... En savoir plus

The Transient Modeling of Bubble Pinch-Off Using an ALE Moving Mesh

C.J. Forster, and M.K. Smith
Georgia Institute of Technology, Atlanta, GA, USA

The use of an acoustic field to control the boiling process has the potential to increase the overall rate of heat transfer and delay the critical transition to film boiling. This system is being investigated through the development of a model of a single boiling bubble near a flat, ... En savoir plus

Numerical Simulations of a Subsonic/Supersonic Coaxial Jet for an Efficient Design of Experimental Setup

D. Guariglia[1], C. Schram[1]
[1]von Karman Institute for Fluid Dynamics, Sint-Genesius-Rode, Belgium

The flow field of a coaxial jet with the internal (primary) flow being subsonic and the external (secondary) flow being supersonic has been investigated with COMSOL Multiphysics® software. We used the results to correct defects in the nozzle geometry and we evaluated the effect of heat ... En savoir plus

Hydrophone Acoustic Receiver Modeling: Turbulent Flow Modeling and Acoustic Analysis

D. Groulx[1], A. Bharath[1], S. Campbell[1]
[1]Department of Mechanical Engineering, Dalhousie University, Halifax, NS, Canada

The field of underwater acoustics research is constantly growing with the ongoing improvement of acoustic measuring techniques. An acoustic hydrophone receiver is a passive listening device which is widely used in biological research and sonar technology. The hydrophone however suffers ... En savoir plus

Material Flow around a Bobbin Tool for Friction Stir Welding

J. Hilgert, L. Hütsch, J. Dos Santos, and N. Huber
GKSS Forschungszentrum GmbH, Geesthacht, Schleswig-Holstein, Germany

This study presents an approach to model the material flow around a bobbin tool for Friction Stir Welding (FSW). In this CFD model the aluminum is treated as a highly viscous non Newtonian shear thinning liquid. The model is formulated in a 3D Eulerian frame. The temperature field and ... En savoir plus

Electromagnetic Force Simulations on a Reaction Sphere for Satellite Attitude Control

L. Rossini[1], E. Onillon[1], O.Chetelat[1], and C. Allegranza[2]
[1]Centre Suisse d’Electronique et Microtechnique, Switzerland
[2]ESA/ESTEC, The Netherlands

In the frame of an ESA project, CSEM in collaboration with other partners has developed an innovative Attitude Orbit Control System concept that relies on a Reaction Sphere. We propose to use one unique magnetic bearing Reaction Sphere whose spin axis and angular velocity can be ... En savoir plus

Premier

491–500 of 1354

Dernier