Articles techniques et présentations

In this paper it is shown how the equivalent circuit parameters of a MEMS resonator can be simply obtained from an eigenfrequency simulation. Additionally, it is demonstrated that the Q-factor as a result of support losses in a MEMS resonator can be determined using a matched boundary ... En savoir plus

A micromirror or a torsional actuator in general has been proven to be one of the most popular actuators fabricated by Micro-Electro-Mechanical System (MEMS) technology in many industrial and biomedical applications such as RF switches, a laser scanning display, an optical switch matrix, ... En savoir plus

This study is a part of the Silent Wall ANR project, to which the Center of Mathematical Morphology is associated. Its main objective is to build an acoustical and thermal insulating system for buildings, composed of fibrous materials. The material is composed of two phases: the fibrous ... En savoir plus

An automated design tool using COMSOL Multiphysics 3.5a and a genetic algorithm was developed to improve the performance of a MEMS resonant mass sensor. The device was comprised of a fixed-free poly-silicon micro-cantilever beam with electrostatic actuation and capacitive sensing. The ... En savoir plus

MEMS gyroscope technology provides cost- effective method for improving directional estimation and overall accuracy in the navigation systems. This paper presents a tuning- fork gyroscope (TFG) [1] with a perforated proof mass. The perforated proof mass used in the design enables the ... En savoir plus

Combustion instability has been a serious issue through the developmental history of gas turbine augmentors. When heat release rate oscillations occur in phase with resonant chamber acoustic modes, a feedback cycle is formed in which the strength of local heat release rate and chamber ... En savoir plus

COMSOL Multiphysics software, when properly configured, can readily solve modeling problems in the laminar flow regime using the standard Navier-Stokes equations or in the fully turbulent flow regime using the kappa-epsilon model. Failure to solve a particular model is typically ... En savoir plus

Manuel Collet is a member of the Department of Applied Mechanics of the FEMTO-ST Institute. He graduated with a degree in Mechanical Engineering from Ecole Centrale de Lyon in 1992 and obtained his PhD in 1996 about Active control of vibrating structures by mean of semi distributed ... En savoir plus

Cantilever vibration modes were simulated with COMSOL Multiphysics. In the 1st approach the model consisted of an excitation piezo, a holder plate and a chip where the cantilever was mounted on. A sinusoidal voltage signal was applied to the piezo in the simulation, which resulted in ... En savoir plus

Vibrations are an essential part of our day to day engineering environment, which happen in automobiles, avionics, machines, electric motors, structures, electronic equipments, etc. When a system is vibrating under higher frequencies leads to higher displacement, noise and heat ... En savoir plus