Articles techniques et présentations

In this experiment, the performance of a Printed Circuit Heat Exchanger (PCHE) was studied using COMSOL Multiphysics® software. PCHEs are diffusion bonded heat exchangers containing semicircular, chemically etched flow paths. Helium was used as the working fluid on both the hot and cold ... En savoir plus

The U.S. Army Corps of Engineers is currently investigating the use of infrasound sensors to monitor the health of structures of interest. Infrasound is low-frequency (2-20 Hz) acoustic energy and is capable of propagating many kilometers from the source structure. Large infrastructure, ... En savoir plus

Verifying that a local software installation performs as the developer intends is a potentially time consuming but necessary step for nuclear safety related codes. Automating this process not only saves time, but can increase reliability and scope of verification compared to ‘hand’ ... En savoir plus

Ongoing studies by the US Army Engineer Research and Development Center (ERDC) are investigating infrasound as a means of persistent monitoring and scour detection at bridges through analysis of the frequency change of the structure caused by altered boundary conditions. Bridges ... En savoir plus

Conventional swing is one phenomenon which a bowler uses to gain an advantage over the batsman. This study involved simulating conventional swing in the CFD Module of COMSOL Multiphysics® software and comparing the simulated results with experimental results of previous researchers. The ... En savoir plus

Stockton University has one of the largest closed loop geothermal system in North America. It provides heating and cooling for the university academic facilities. The well field comprises of a grid of four hundred wells bored to a depth of 130m. The ground is composed of three aquifers ... En savoir plus

One of the most effective treatments for diabetes type 1 and 2 is the administering Insulin. The design of positive volumetric insulin pump is significantly a multiphysics problem where the volumetric change of the main pump chamber and the pumped fluid are directly coupled. We used ... En savoir plus

In order to achieve an optimized design of the Multi-Lumen Thoracic Catheter (MLTC), fluid dynamics analyses were conducted utilizing COMSOL Multiphysics® software with LiveLink™ for Solidworks®. Lumen placement, diameters, and termination points were adjusted to ensure maximum drainage ... En savoir plus

Delayed Coking is a refining process, which takes heavy petroleum residue as a feed. A 2D axisymmetric stationary model was created to simulate this pre-run condition with nitrogen gas, as an attempt to calibrate the model before simulating with an oil residue. The single-phase laminar ... En savoir plus

Introduction The electrical properties of materials are important in many different applications. In microelectronics for example, films must perform as insulators, semiconductor or as conducting layers. In recent years, scanning probe methods are being extended to the nanometre scale ... En savoir plus