Articles techniques et présentations

Recherche rapide

Ressources

Livres Blancs

Voyez comment la modélisation et la simulation sont utilisées par les industries La modélisation et la simulation multiphysiques pilotent l'innovation dans tous les grands secteurs d'activité et dans le monde universitaire — comme en témoignent les nombreuses utilisations présentées dans des articles et des posters techniques présentés par des ingénieurs, chercheurs et scientifiques à la Conférence COMSOL chaque année. Inspirez-vous des récents proceedings réunis ci-dessous, ou, pour trouver les présentations les plus intéressantes dans votre domaine d'intérêt, utilisez la recherche rapide.

Consultez les proceedings de la Conference COMSOL 2024

Terme recherché:

Inclusive Routine of the Soil Surface Energy Balance in COMSOL Multiphysics®

M. Bortoloni[1], M. Bottarelli[2], Y. Su[3]
[1]Department of Engineering, University of Ferrara, Este, Italy
[2]Department of Architecture, University of Ferrara, Este, Italy
[3]Faculty of Engineering, University of Nottingham, Nottingham, UK

In ground-coupled heat pumps (GCHPs) the coupling between heat pumps and ground occurs by means of ground heat exchangers, that can be installed vertically inside boreholes (BHEs) or horizontally (HGHEs). In the horizontal installation, the heat exchangers are placed in shallow trenches ... En savoir plus

Natural Refrigeration System Design

A. Prasad [1], O. K. Sacks [1], R. C. Thiagarajan [1],
[1] ATOA Scientific Technologies, Bengaluru, India

This paper deals with the numerical experiments for early prediction of muffler performance at the design stage. In this experiment a Reactive Muffler is developed and validated numerically compared to traditional built and test process. En savoir plus

Thermal Modeling in a Historical Building - Improving Thermal Comfort Through the Siting of a Passive Mass of Phase Change Material

D. Groulx[1], F. Herbinger[1], L. Desgrosseilliers[1]
[1]Mechanical Engineering, Dalhousie University, Halifax, NS, Canada

A model of an office room was created in the COMSOL Multiphysics® software to simulate heat transfer and study the impact of siting a mass of phase change material (PCM) in a room to increase thermal comfort. This study determined that incorporating the selected PCM, butyl stearate, in ... En savoir plus

Two-dimensional Model of a Lithium Iron-Phosphate Single Particle

M. Cugnet [1][2],
[1] Université Grenoble Alpes INES, Le Bourget du Lac, France
[2] CEA, LITEN, Grenoble, France

Introduction: Lithium-ion batteries are widely used as power sources for portable electronic devices (laptop, phones, and players) and electric cars due to their high energy density. New applications, such as Formula E, require also a huge power capability that the iron-phosphate-based ... En savoir plus

Finite-Element Evaluation of Thermal Response Tests Performed on U-Tube Borehole Heat Exchangers

E. Zanchini, and T. Terlizzese
[1]Dipartimento di Ingegneria Energetica, Nucleare e del Controllo Ambientale, Università di Bologna, Bologna, Italy

The results of two thermal response tests recently performed on two vertical borehole heat exchangers (BHEs) are presented. The BHEs have the same cross section and a depth of 100 m and 120 m respectively. The evaluation of the thermal properties of the ground and grout are performed by ... En savoir plus

Fully Coupled Thermo-Hydro-Mechanical Modeling by COMSOL Multiphysics, with Applications in Reservoir Geomechanical Characterization

T. Freeman[1], R. Chalaturnyk[1], and I. Bogdanov[2]
[1]University of Alberta, Edmonton, AB, Canada
[2]Centre Huile Lourde Ouvert et Expérimental (CHLOE), France

Because of the complex nature of geomaterials and presence of solid and fluid within a single system, it is crucial to consider all the physics involved within the geomaterial system. A fully coupled thermo-hydromechanical model is developed. The model consists of a three-phase flow ... En savoir plus

3D Numerical Modeling of Vertical Geothermal Probes

J. M. Dedulle [1], D. Nguyen [2]
[1] SIMTEC, Grenoble, France
[2] BRGM, Montpellier, France

The Solargeotherm project is assessing the possibility of using vertical geothermal probes drilled into a rock mass (bedrock) for storing the thermal energy produced by solar panels and later releasing it. The research project relies on the installation of an experimental system and the ... En savoir plus

Impact of Electrode Surface/Volume Ratio on Li-ion Battery Performance

S. Das[1], J. Li[2], R. Hui[1]
[1]University of Kansas, Lawrence, KS, USA
[2]Kansas State University, Manhattan, KS, USA

The adoption of micro- and nanostructured electrodes is a promising technique to improve the performance of Li-ion battery, which increases the electrode surface area and improves the efficiency of ion exchange between the electrode and electrolyte. This performance improvement is ... En savoir plus

Simulation of Sample Inhomogeneity in Microwave Impedance Microscopy

T. S. Jones [1], C. R. Pérez [1], J. J. Santiago-Avilés [1],
[1] University of Pennsylvania, Philadelphia, PA, USA

Microwave impedance microscopy (MIM) is a novel mode of atomic force microscopy that can measure topography and local electrical impedance simultaneously and with nanometer spatial resolution [1]. This technique is typically used qualitatively, identifying defects in nanodevices or ... En savoir plus

Simulation Tests of the Constitutive Equation of a Nonlinear Viscoelastic Fluid

A. Czirják [1], Z. Kőkuti [1], G. Tóth-Molnár [1], G. Szabó [1], P. Ailer [2], L. Palkovics [2]
[1] University of Szeged, Szeged, Hungary
[2] Kecskemét College, Kecskemét, Hungary

The determination of the constitutive equation of a nonlinear viscoelastic fluid is a challenging task, especially if a space-dependent equation is needed [1]. In this contribution, we present simulations of certain rheometry tests of a high-viscosity nonlinear viscoelastic fluid with a ... En savoir plus

Premier

301–310 of 505

Dernier