Articles techniques et présentations

COMSOL Multiphysics along with its LiveLink™ for MATLAB® is used to investigate the needed number of elements and the required order of Lagrangean p element for a number of different simulation models. For this task, convergence study, speed up testing and interactive meshing is ... En savoir plus

Composite repairs involve applying a prescribed heat flux which must be adjusted to account for heat losses. These losses must be estimated. Parameter estimation requires a knowledge of sensitivities. This is often done using finite differences. As shown in the figure, substantial errors ... En savoir plus

Magnetic separation of magnetic liquid phases/particles from non-magnetic liquid phases/particles are needed for applications such as cleaning up oil spills by separating oil and water liquid phases or separating magnetic materials from non-magnetic materials in biomedical and ... En savoir plus

The technique of water calorimetry for primary-standard dosimetry of radiotherapy-level ionizing radiation is well established at national metrology institutes around the world, where such a direct realization of absorbed dose establishes the basis for calibrating instruments used for ... En savoir plus

Experimental data for oscillations occurring at the three phase contact line of an evaporating HFE 7000 meniscus on a silica substrate is presented. The frequency of the oscillations were found to depend on the local value of the evaporative heat ?ux. The thickness, slope, and curvature ... En savoir plus

We have started constructing preliminary design COMSOL models of a bacteriologically driven \'fuel cell\' that is intended to process waste products, such as carbon dioxide and brine, from a crewed vehicle. At this early stage, this complex system is reduced to two electrodes separated ... En savoir plus

Magnetic cantilever measurements have detected half-flux states in mesoscopic rings of the layered material Sr2RuO4, adding evidence that superconducting Sr2RuO4 may be described by a p-wave order parameter. A proposal accounting for this behavior has been presented in which the ... En savoir plus

The challenge with the use of Sodium Carbonate Peroxyhydrate (Na2CO3*1.5H2O2) as a bleach source in dry detergent formulations is its lower stability in comparison with other materials, and the risk of quality losses of the product over the shelf life. The issue can be solved with the ... En savoir plus

Powder detergents containing sodium percarbonate and bleach activators undergo chemical decomposition when exposed to high relative humidity. Controlling the moisture intake in finished product packs is therefore a fundamental need in order to guarantee product stability during the whole ... En savoir plus

This paper presents thermo-mechanical models for predicting the strength of polymer laminates loaded in tension or compression exposed to one-sided radiant heating by fire. The first part is the fire simulation where the FDS model is utilized. The FDS model generates a solution of ... En savoir plus