- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
A piezoelectric transformer allows purely mechanical transfer and scaling of electrical energy via simultaneous utilization of both the direct and converse piezoelectric effects. This mechanical energy transfer enables a wide range of functional differences from typical magnetic-based ... En savoir plus
A scheme for inductive wireless powering and readout of passive LC sensor is presented. The sensor’s inductor is designed as a planar square coil and is used as the power receiving component. The capacitor is connected directly to the inductor and it was designed as an interdigital ... En savoir plus
In recent years, the single-sided linear induction motor (SLIM) has been the most suitable choice for electric vehicles of the wheel and touchless type. The reason is simplicity in manufacturing, capability in applying direct force, moving and braking and low pollution. To study the ... En savoir plus
A microwave heating model coupled with heat, mass, and momentum transfer is needed to fully understand the microwave heating process. In this study a comprehensive 3D model was developed for studying the interaction of microwave with the food. The model includes physics of Maxwell’s ... En savoir plus
Although mammography is extremely important diagnostic technique, it suffers from some limitations such as false negative and positive results, using ionizing radiation and patient’s discomfort. Microwave imaging has been recently proposed as an additional medical imaging technique ... En savoir plus
This paper presents the electrical and thermal analysis of an OLED module. The OLED module consists of the OLED tile and the DC-DC converter incorporated in its backplane. The DC-DC converter is realized as an integrated circuit and its inductor is embedded in the the backplane. The DC ... En savoir plus
We study the topography influence of levees on the electric resistivity signal obtained with the Radio-Magnetotelluric method. Field measurements have been modeled with COMSOL, using the AC/DC and RF Modules. A levee situated in Orléans along the Loire river (France) has been considered ... En savoir plus
This paper will describe some applications of COMSOL Multiphysics to the analysis of Frequency Selective Surface (FSS) structures. Particular attention will be devoted to the possibility of designing a stealthy antenna using the FSS structure. In fact, since it possesses a dual filter ... En savoir plus
FMR spectra of the periodic microstructures (one-dimensional magnonic crystals, 1D MCs) were obtained using COMSOL with use partial differential equation interface. Results of these calculations were successfully compared with an experimental data for Damon-Eshbach (DE) and Backward ... En savoir plus
COMSOL Multiphysics has been widely used to model the near and far-field electromagnetics (specifically, transmission and reflection spectra) of gold and silver nanoantenna arrays. We use a moving 3D mesh, thus preserving the DOF number and simply morphing the structure of the mesh ... En savoir plus
