Articles techniques et présentations

YBCO Coated Conductors (CCs), used for applications in Resistive Superconducting Fault Current Limiters (RSFCLs), are known to have insufficiently high Normal Zone Propagation Velocity (NZPV) during quench events. The improvement can be made by enhancing the thermal conductivity of YBCO ... En savoir plus

Ohmic heating (Joule heating) is a volumetric heating technology which can effectively process almost any pumpable fluid with extremely high energy efficiency (>95%). This is particularly useful for very thick fluids, those that burn on to hot surfaces and those with high solids content ... En savoir plus

A model built with COMSOL Multiphysics® to exploit meteorological forecasts and instant outdoor meteorological data (temperature, solar radiation, moisture, wind speed and direcition, etc.) together with indoor ambient data (air temperature, radiant temperature of enclosures, etc), ... En savoir plus

For biocompatible prosthetics, from dental implants up to bone parts, manufacturers have to find the best way to correlate process parameters and the material properties as to meet the unique needs of individuals. Additive manufacturing techniques aim at creating complex biocompatible ... En savoir plus

The COMSOL's Heat Transfer module was used in this study to evaluate the temperature distribution in concrete box-girders subjected to exterior thermal conditions. The included thermal loads were air temperature, wind speed in addition to solar radiation. Moreover, the reflected ... En savoir plus

Corrugated board is produced on a machine where the corrugated medium is glued between two flat paper surfaces, the liners. The board is cut into sheets and stored in a stack until suitable moisture content has been reached. The sheets are then cut and creased into blanks for the ... En savoir plus

COMSOL Multiphysics® software is used to model the field joint application process on carbon steel pipelines for deep sea crude oil transportation, taking into account not only heat transfer, cure kinetics, and crystallization, but also thermal, cure and crystallization shrinkage and the ... En savoir plus

In the paper, first a basic concept of the engineering approach for modeling and control of distributed parameter systems (DPS) based on interpretation of controlled systems as lumped input and distributed output systems (LDS) is introduced. Next, FEM modeling of temperature fields in ... En savoir plus

Porosity in carbon fiber reinforced polymers (CFRP) as shown in figure 1 degrades the engineering performance, especially the interlaminar shear strength [1]. In the aviation industry a porosity level of 2.5 % has become the maximum level of acceptance. The presence of air-filled voids ... En savoir plus

The implementation of thermal insulation in old residential building walls could compromise the hygrothermal behavior of the construction, especially in summer time when it is placed inside. A bad installation of insulation could have consequences on the quality of indoor air conditions ... En savoir plus